Dining Room Chandelier Height & Size Rules 2027 (Stop Guessing)
A chandelier is the one thing everyone looks at and nobody knows how to choose. Too small and it disappears. Too low and nobody can see across the table.
Quick summary:
| Rule | What to do |
|---|---|
| Height above the table | 30 to 36 inches from tabletop to bottom of chandelier |
| Diameter | One-half to two-thirds of the table width |
| Room-size check | Room length + width in feet = chandelier diameter in inches |
| High ceilings | Add about 3 inches of height for each extra foot above 8 feet |
| Open floor (no table) | Bottom of chandelier at least 7 feet above the floor |
| Light colour | 2700K warm white, dimmable, always |

Get the height and the size right and the chandelier does the decorating for you.
How High Should It Hang?
- 30 to 36 inches above the tabletop, on an 8 ft ceiling. Measure to the bottom of the fixture, not the top.
- 30 inches feels intimate. 36 inches gives better sightlines across the table.
- Add 3 inches per extra foot of ceiling. 9 ft means 33 to 39 inches. 10 ft means 36 to 42 inches. 12 ft means 42 to 48 inches.
- Cap it at about 48 inches. Higher than that, it disconnects from the table it is meant to light.

Measure from the tabletop, not the floor. That is the most common height error.
How Big Should It Be?
- One-half to two-thirds of the table width. Measure the short side of the table.
- 48 inch table wants 24 to 32 inches. 60 inch table wants 30 to 40 inches. 72 inch table wants 36 to 48 inches.
- Never wider than the table. Overhang looks heavy and worries tall guests.
- Too small is the number one mistake. A 16 inch pendant over a 72 inch table just floats there. When torn between two sizes, go bigger within the range.
Round or Rectangular Table?
- Round table, round chandelier. One-half to two-thirds of the table diameter. A 48 inch round table wants about 24 inches.
- Rectangular table, linear chandelier. A round one leaves the ends dark. Linear length is one-half to two-thirds of the table length.
- Stay 12 inches short of each end. The light should not reach the very edge of the table.






